徠卡顯微鏡系統
雷射掃描共軛焦顯微鏡
半導體及工業用顯微鏡
顯微數位影像系統
細胞基因影像分析系統
其它光電微機電系統
其它生醫研究儀器
維修與技術支援服務
聯絡與留言

顯微鏡光源, 光譜波長切換裝置.

Microscope Light Sources & Wavelength switching system.

Leica EL 6000

可達 2000 小時, 最佳使用投資效益. ( 依測試, 當使用 3000 hours 後, 仍有 50% 的輸出效率 ). 平均一支燈管的使用壽命約等於 7 支 HBO 燈管. 最符合經濟效益, 5 段式衰減, 0%, 12.5%, 25%, 50%, 100%. ( 可配合 Leica IFW 及 FIM 控制 ), 內建快門控制, 切換速率高達 4 msec. 可選配安裝螢光濾鏡轉盤 ( Filter wheel ), 可適用其他廠牌顯微鏡 ( 配合特定安裝固定座 )
超高速光譜波長切換裝置 ( Ultra High Speed Wavelength Switcher DG4 )
微電腦控制超高速光譜波長切換器
內建 175 W Xenon 光源 ( 300 - 700 nm ), 光纖導光.
光波切換採用超高速 Galvanometer 掃描.
光波切換速率比單光儀 (  Monochromator ) 快 1000x 以上, 可達 1.2 msec.
可被大部分影像軟體驅動, 亦可由電腦執行 32 組以上的波長切換程序.
適用所有廠牌顯微鏡
微電腦控制可程式濾鏡轉盤

( Programmable Filter Wheel )

Leica DM IRE 2 內建電控 4x 螢光濾鏡轉盤, Leica DMI-6000B 內建 6 組螢光濾鏡轉盤, 內建可見光源控制快門, 同時可外接 2 組濾鏡轉盤 ( Excitation 及 Emission )

Leica DM R 系列內建電控 4x 或 8x 孔螢光濾鏡轉盤.

Sutter Lambda 10

可程式濾鏡轉盤, 內建快門. 雙頻道控制器可同時控制 2 組濾鏡轉盤. 55 msec 濾鏡切換速率. ( 最高可裝置 12 個濾鏡, 有 25 mm , 32 mm, 50 mm 口徑濾鏡可供選用 ). 可安裝於 Excitation Port 或 Detection Port ( Emission port )

Sutter Lambda 10-B

可程式濾鏡轉盤, 內建快門. 雙頻道控制器可控制 1 組濾鏡轉盤. 40 msec 濾鏡切換速率 ( 當控制 10 個濾鏡轉盤 ). 31 msec 濾鏡切換速率 ( 當控制 3 個濾鏡轉盤 ).( 最高可裝置 10 個濾鏡, 有 25 mm , 32 mm, 50 mm 口徑濾鏡可供選用 ). 可安裝於 Excitation Port 或 Detection Port ( Emission port ), 內建 USB Interface 及 Serial port.

 

Sutter Lambda 10-B

可程式濾鏡轉盤, 內建快門. 雙頻道控制器可控制 3 組濾鏡轉盤. 40 msec 濾鏡切換速率 ( 當控制 10 個濾鏡轉盤 ). 31 msec 濾鏡切換速率 ( 當控制 3 個濾鏡轉盤 ). ( 最高可裝置 10 個濾鏡, 有 25 mm , 32 mm, 50 mm 口徑濾鏡可供選用 ). 可安裝於 Excitation Port 或 Detection Port ( Emission port ), 內建 USB Interface 及 Serial port.

可安裝附加 Sutter SmartShutterUniBlitz 電子快門.

 

SmartShutter 高速電子快門

Opening time 8 msec from trigger (for 25mm & 35mm versions)

Continuous operation frequencies as high as 40Hz

Stand-alone or use with Sutter filter wheel

Mountable in Lambda LS and Lambda DG-4/DG-5

Microprocessor based controller

“Soft” action mode provides minimum vibration

Selection partial opening function for neutral density

Serial, USB and TTL interfaces

Manual input via keypad

Universal power supply

LAMBDA SC
SmartShutter Controller 快門控制器
 
The Lambda SC is a full-featured microprocessor controlled shutter driver for the SmartShutter. It supports the same shutter command set used for our other Lambda controllers and offers enhanced performance through additional of modes of operation. The additional operating modes allow programmable control over the exposure time, and the delay between trigger and shutter opening.

In the Lambda 10 family of filter wheel controllers, shutter timing is controlled directly by the time of occurrence of commands or TTL input. In most cases, the system software used with these controllers has provisions for controlling the timing of the shutter. The Lambda SC shutter controller may be used in applications that would benefit from enhanced control options built into the controller. The controller can operated remotely from a computer through the USB port, or opened and closed using a logic level input.

In the free running mode, the shutter will open and close repeatedly. The time between closing and reopening can either be directly timed, or set as an interval for the entire cycle. Delay and exposure intervals can be set by the user for up to 5 hours with millisecond resolution. This mode can be set to continuously run or loop for a specific number of cycles. The mode is initiated from power up, or a trigger pulse, and can be interrupted by using a stop command.

Because the SmartShutter incorporates a microprocessor controlled motor/wiper design, the trajectory of each move can be controlled and the motion of the blade optimized for speed or for smoothness. When speed is the most important condition, the user can select the fast mode. If the modest amount of vibration in the fast mode is objectionable and speed is not important, the “soft” mode can be selected, moving the blade slower through the overall travel.

The neutral density mode results in a partial opening of the SmartShutter. Any one of the 144 steps from a fully closed to fully open can be selected. Using this variable aperture opening along with a liquid light guide acts to spatially homogenize the light to produce a uniform spatial illumination that’s independent of the geometry of the input illumination.

 

Sutter Lambda 10-C

可程式濾鏡轉盤, 內建快門. 單頻道控制器. ( 最高可裝置 12 個濾鏡, 有 25 mm , 32 mm, 50 mm 口徑濾鏡可供選用 ). 可安裝於 Excitation Port 或 Detection Port ( Emission port )

 
顯微鏡安裝配件 Type of Adapter 選購號碼
Leica DMR (L10) 

正立顯微鏡

EXCITATION 10-L10-EC
EXCITATION-32mm 32-L10-LH
EMISSION 10-L10-EM
LAMP HOUSING 10-L10-LH
LIGHT GUIDE LG-L10
Leica DMIRB & DMIRE2 (L20) 

倒立顯微鏡

EXCITATION 10-L20-EC
EXCITATION-32mm 32-L20-LH
EMISSION* 10-L20-EM
LAMP HOUSING 10-L20-LH
LIGHT GUIDE LG-L20
LIGHT GUIDE*
(internal)
LG-L20-I

UniBlitz 超高速電子快門

適用所有廠牌顯微鏡

超高速電子快門 ( UniBlitz shutter )
Series Aperture Time to Open
CS25 25 mm 9.0 m sec
CS45 45 mm 14.0 m sec
CS65 65 mm 29.0 m sec
CS90 90 mm 70.0 m sec
Series Aperture Time to Open
LS2 2 mm 300 µ sec
LS3 3 mm 500 µ sec
LS6 6 mm 700 µ sec
Series Aperture Time to Open
VS14 14 mm 1.5 m sec
VS25 25 mm 3.0 m sec
VS35 35 mm 13.0 m sec
Series Aperture Time to Open
XRS6 6 mm 3.2 m sec
XRS14 14 mm 20.0 m sec
XRS25 25 mm 10.0 m sec
Series Aperture Time to Open

UHS1

1 mm 180 µ sec
LUDL 可程式濾鏡轉盤, 內建快門. 模組式控制器. ( 可裝置 25 mm 及 32 mm 口徑濾鏡 ). 可安裝於 Excitation Port 或 Detection Port ( Emission port )

Monochromator

單光儀

Leica Monochromator ( 連續波長切換單光儀 )

目前架設於 Leica AS MDW. 

提供 75W - 250 W Xenon 光源, 超高速光波切換, 光纖傳導.

 

PolyChrome IV ( 連續波長切換單光儀 )

150 Watt Xenon  lamp, wavelength selection via galvanometric scanner, wavelength range 320 and 680 nm, bandwidth 8 - 15 nm, rapid wavelength switching between all wavelengths in less than 3 ms, continuous spectrum, quartz fiber with UV optimized coupling into all major microscopes, zoom epifluorescence condenser for variable field of illumination 

顯微鏡光源

( 適用所有廠牌顯微鏡  )

光纖傳導光源 ( 175W Xenon light sources )

Microscope Xenon Lamp with Optical Fiber coupling. 

可安裝一組可程式濾鏡轉盤

Microscope Lamp Housing & Power supply

顯微鏡燈箱及電源供應器, Hg / Xenon light sources. 可同時使用 2 組燈箱.

UV-Flash Lamp 

( Uncage, Flash Photolysis, Spot Bleaching )

- Pulse length:                1 µs .... 10 ms
- Wavelength range:        190 .... 2000nm
- Repetition rate:             > 500 Hz
- Pulse energy:                > 5 kJ
- Average power:            > 5 kW

Laser Sources

IR-laser ( laser tweezer )

UV-laser ( laser micro-dissection )

Blue laser ( FRET / FLIM application )

其他生醫研究儀器首頁
美嘉儀器股份有限公司 Major Instruments Co., Ltd.
台北總公司 : TEL : 02-2808-1452  FAX : 02-2808-2354  維修中心 : 02-2808-2353   高雄辦事處 - TEL : (07) 725-8177  FAX : (07) 725-8204

E-mail : major@major.com.tw    http://www.major.com.tw